Understand Message Codes - Oce TDS100 User Manual

Understand message codes

Introduction
The Océ TDS100 displays a message code when the copier is not ready to use.
The following table shows a summary of the messages codes, the possible
cause and the action to take.
What the message code describes
Code
E 0
E 1
E 2
E 3
36 User manual
Possible cause
The original is jammed
The media feed stopped
during a copy job
The red stop key was pushed
during a copy job.
The manual feed table is open.
The copy media is too short.
The media is jammed
The cut off strip is not
removed.
Action
Clear the original jam
(see 'Clear an original jam' on
page 41)
Clear the media jam
(see 'Clear a media jam' on
page 43)
Clear the original jam
(see 'Clear an original jam' on
page 41)
Clear the media jam
(see 'Clear a media jam' on
page 43)
Open the middle cover and
lift the manual feed table
(see figure 19 on page 44)
Use longer cut sheet media
Check the media feed
(see 'Clear a media jam' on
page 43)
Remove the cut off strip
(see 'Straighten the edge of a
media roll' on page 34)