Oce TDS100 User Manual page 26

Set up your copy job at the operator panel
2.
Use the 'Media' key to select the media type to copy on.
When you press the media key, one of the following situations occur.
- The selected media and corresponding roll illuminates. The operator panel
displays the size of the media roll. If the size of the media roll is not correct,
you need to replace the media roll (see 'Replace a media roll' on page 46).
- You can not select the media, because the requested media is not loaded.
You need to replace a media roll (see 'Replace a media roll' on page 46).
If both media rolls of the 2 roll configuration contain the same media, use
the 'Feed' key to select the roll with the correct size.
Use the exposure key to correct the background of the copy.
(see 'Improve the copy quality of dark and light originals' on page 32).
Use the 'Strip' key and adjustment key to add or remove a leading or trailing
strip.
(see 'Adjust leading and trailing strips' on page 29).
Use the 'Cut' key to select the cut method.
Use the copies key to set the number of copies.
Press the green start button to start the copy job.
3.
Result
The Océ TDS100 runs the copy job with automatic media feed.
26 User manual