Turn On The Océ Varioprint 2105 - Oce VarioPrint 2105 Manual For Use

Turn on the Océ VarioPrint 2105
Introduction
This chapter describes the different procedures to turn on the printer-only
configuration and the hybrid configuration of the Océ VarioPrint 2105.
Before you begin
Empty the output trays of the finisher.
Make sure that the paper trays do not contain more sheets than the
specifications allow.
Upper tray: Letter-standard / 1000 sheets of 20 lb. bond
Middle tray: Letter-standard / 1000 sheets of 20 lb. bond
Lower tray: Letter-standard / 3000 sheets of 20 lb. bond
If you load more sheets, the Océ VarioPrint 2105 may not become warm
because some switches in the paper tray are opened.
How to turn on the hybrid configuration
Press the power switch (
1
The Océ Smart Imager starts up. The following occurs.
The green LED on the monitor of the control station blinks.
The screen of the operator panel is off/black.
Press the power switch (
2
Wait for 2 minutes, then the screen displays the Océ VarioPrint 2105 logo.
Wait until the screen displays the 'Standard templates'.
Press the On/Off button (
3
button changes to green.
Press the On/Off button (
4
button changes to green.
How to turn on the printer-only configuration
Press the power switch on the Océ Smart Imager.
1
The Océ Smart Imager starts up.
The following occurs.
The green LED on the monitor of the control station blinks.
The screen of the operator panel is off/black.
Introduction
) on the scan station.
) on the print station.
) on the scan station. The LED in the On/Off
) on the print station. The LED in the On/Off
43