Nhtc/Pc Start Up Checklist - Nortec NHTC Installation And Operation Manual

NHTC/PC Start Up Checklist

Unit Serial #: _________________
Unit type: _______ __________
Cylinder Type:
Preliminary:
 Pre-start-up checklist completed?
If no, perform Pre-Start-up Checklist before starting humidifier.
Start-Up Procedure:
The prerequisites for the humidifier filling and contactor pulling in to make steam are as follows:
 Door in Place and secured with screw
 Water supply valve opened
 Mains disconnect switched on
 Turn On/Off switch on
 On/Off Security loop (Terminal 1 and 2) closed.
Controls:
 Installed Controls Match Configuration
 Control Setpoint:
 Demand (Modulating Humidistat)
or
 Sensed RH < Setpoint (Transducer)
The Humidifier will undergo a self-test when the power is turned on activating the LED's and other
internal components.
If the above listed prerequisites are fulfilled the humidifier will start filling the cylinder and begin
normal operation.
Note: Most water does not contain enough conductivity for full boil on initial start-up. Units
will need to concentrate the water over a time period (hours to days). It is normal for
W12 Sensor on warning indicating water level is at the top of the cylinder to be
displayed during this time period.
Remarks:
Started by:
Company:
Tag: _______________
Voltage: ______V/____ph
Customer/Job:
yes 
High Limit Setpoint:
Date of Start Up: _______/_______/______
Steam output: ______ lb/hr
Address:
yes  no 
yes  no 
yes  no 
yes  no 
yes  no 
yes  no 
no 
yes  no 
yes  no 
Start Up | 40