Service Level; User Defined Settings - Nortec NHTC Installation And Operation Manual

Service Level

The selections in the Service Level allow you to reset service reminders and the fault history.
Press Set while highlighting Service Level in the Main Menu.

User Defined Settings

The selections in User Defined Settings allow you to configure most user configurable features
available with the NHTC. Press Set while highlighting User Defined Settings in the Main Menu.
Reset Cylinder
The humidifier uses information
about cylinder replacement to
optimize the performance of the
humidifier. Only after replacing a
cylinder select Reset Cylinder,
and then press the Yes button.
Reset Error History
Deletes the list of errors stored in
the error history. The Error
History is located in the
Diagnostics Menu. Resetting the
error history is not normally
required, but can be done after
repairs to remove faults that are
no longer needed.
Reset Service History
Deletes the historical list of
service reminders. The Service
History can be found in the
Diagnostics Menu.
Multi Mode
Use Multi Mode to configure the
humidifier to operate as one
humidifier of a group controlled
by a single control signal /
transducer signal. See Multi Unit
Op. Range later in this section.
(Default = Standalone)
Operation | 48