Connect Computers To Second-Tier Masterconsole(S) - Raritan MCC4 User Manual

Keyboard/video/mouse (kvm) switches

Hide thumbs Also See for MCC4:

User manual (46 pages)

Table Of Contents

Table of Contents

Using a Universal cable kit (CCPnnU), plug the 25-pin

connector into one of the numbered Channels on the

base MasterConsole II back panel.

Plug the cable's other connectors into the Keyboard,

Monitor, and Mouse ports of the second-tier

MasterConsole II or MasterConsole P Model.

Power on the MasterConsole unit according to the follow-

Note: All second-tier MasterConsole P Models must be MasterView

ready. To determine if your P Model does have this feature,

check the white label on the bottom of the unit *. This label

shows the unit's level and style of firmware: MDSP-nnn. If it is

MDSP-1AC or higher (MDSP-1AD, etc.), the unit is MasterView

ready. If not, you need to upgrade. Call Raritan Technical

Support for details.

ing instructions:

IMPORTANT: For MasterConsole II, the unit must be

programmed as a second-tier unit. (The default setting

is first-tier) To program any MasterConsole II as a sec-

ond-tier unit, power ON while pressing the Channel #2

button on the front panel and hold for 3 seconds. When

the unit is programmed as a second-tier unit, the LED

on the far right of the unit's front panel (2ND) will be lit

continuously. Note: Any unit can be re-programmed to

be a first-tier unit by pressing the Channel #1 button on

the front panel during a subsequent power ON process.

For MasterConsole P Model: Turn the power switch on.

Repeat steps 4a through 4c to connect additional second-

tier MasterConsole units to the base MasterConsole II.

For second-tier units located more than 30 feet away

from the base unit, see Remote Access Using Cat5

Reach, page 25.