Table of Contents
Advertisement
14
Setting AutoScan
AutoScan activation shortcut:Activate the On-Screen User
·
Interface and press the F6 Function Key. The green light next to
the <Scan> button on the front panel will be ON and the unit
will scan according to the parameters set in the Configuration
Menu.
Operating MasterConsole II
Using Front Panel Buttons (One-Tier)
When the on-screen user interface is not activated, you can operate
MasterConsole II from the front panel.
The front panel has a <Scan> button, a <Skip> button, and a series of
numbered buttons used to select channels and to set the Global Scan
Rate. See Figure 6 and Figure 7.
1.
To select a computer:
·
Be sure the green light next to the <Scan> button is OFF
(toggle ON/OFF).
Press the numbered button corresponding to desired channel.
·
The light above the selected Channel button turns green,
·
video from the selected computer displays on screen and
you may now operate the selected computer.
· The Channel ID and Name will be displayed on the
screen for the time interval specified in the Configuration
Menu.
2.
To activate AutoScan:
Press the <Scan> button (toggle ON/OFF) The green light next
·
to the <Scan> button will be ON and the unit will scan accord-
ing to the parameters set in the Configuration Menu. If the
AutoScan Mode is set to Individual, AutoScan will occur at the
Channel-Specific Scan Rates as defined in the Edit Names and
Scan Rate Menu.
Advertisement
Table of Contents
