Table of Contents
Advertisement
4
One-Tier Configuration
Installing MasterConsole II (One-Tier)
1.
Shut down and power off all computers to be connected to
MasterConsole II.
2.
Plug a keyboard, monitor, and mouse into the keyboard, moni-
tor, and mouse ports on the MasterConsole II back panel. See
Figure 3 and Figure 4.
3.
Power ON the MasterConsole II unit.
4.
Using a universal cable kit (CCPnnU), plug the 25-pin connector
into one of the numbered channels on the MasterConsole II back
panel.
5.
Plug the cable's other connectors into the computer's keyboard,
monitor, and mouse ports. Use supplied adapters for AT style
PCs. See Figure 5.
6.
Power ON the connected computer.
7.
Select the connected computer by pressing the corresponding
front panel button. Verify that the monitor attached to
MasterConsole II displays the video for the connected computer.
Use the keyboard and mouse attached to MasterConsole II to
verify that they operate the connected computer.
Note:
An amber channel light above a numbered channel button on
the MasterConsole II front panel indicates that the channel is
active; that is, a computer is connected and powered on. A
green light above a numbered channel button indicates the cur
rently displayed channel. See Figure 6 and Figure 7.
8.
Repeat Steps 4 through 7 to connect the remaining computers to
MasterConsole II.
Figure 3. MasterConsole II Back Panel
Advertisement
Table of Contents
