Monitoring The Measurement-Complete Signal - Tektronix DMM4040 User Manual
Hide thumbs
Also See for DMM4040:
- Safety and installation instructions manual (38 pages) ,
- Installation manual (7 pages)
Table of Contents
Advertisement
DMM4040/4050
Users Manual
Monitoring the Measurement-Complete Signal
In addition to being a trigger input, the TRIG I/O jack on the Meter's rear panel also
provides a signal indicating the completion of a measurement cycle. A falling edge of a
TTL signal indicates a measurement cycle is complete. See Figure 4-9 above to identify
which pins on the TRIG I/O connector are used to sense the measurement-complete
signal.
4-20
Advertisement
Table of Contents
