Compliance Information; Emc Compliance - Tektronix DMM4040 User Manual

DMM4040/4050
Users Manual

Compliance Information

This section lists the EMC (electromagnetic compliance), safety, and environmental
standards with which the instrument complies.

EMC Compliance

EC Declaration of Conformity—EMC
Meets intent of Directive 2004/108/EC for Electromagnetic Compatibility. Compliance
was demonstrated to the following specifications as listed in the Official Journal of the
European Communities:
EN 61326-1 2006, EN 61326-2 2006.
measurement, control, and laboratory use.
CISPR 11:2003. Radiated and conducted emissions, Group 1, Class A
IEC 61000-4-2:2001. Electrostatic discharge immunity
IEC 61000-4-3:2002. RF electromagnetic field immunity
IEC 61000-4-4:2004. Electrical fast transient/burst immunity
IEC 61000-4-5:2001. Power line surge immunity
IEC 61000-4-6:2003. Conducted RF immunity
IEC 61000-4-11:2004. Voltage dips and interruptions immunity
EN 61000-3-2:2006.
EN 61000-3-3:1995.
European Contact.
Tektronix UK, Ltd.
Western Peninsula
Western Road
Bracknell, RG12 1RF
United Kingdom
1
This product is intended for use in nonresidential areas only. Use in residential areas may cause electromagnetic
interference.
2
Emissions which exceed the levels required by this standard may occur when this equipment is connected to a test
object.
3
To ensure compliance with the EMC standards listed here, high quality shielded interface cables should be used.
4
The tolerance of the 100uADC, 10mADC ranges while subjected to the test field (3 V/m over the frequency range
of 80 MHz to 1 GHz, 1.4 GHz to 2.0 GHz, and 1V/m from 2.0 GHz to 2.7 GHz, with 80% amplitude modulation
at 1 kHz) can increase by +/- (0.06% of range) over the frequency range of 1.7 - 1.9GHz. (IEC 61000-4-3).
5
The tolerance of the 100uADC, 10mADC ranges while subjected to the injected test signal (3 V rms over the
frequency range of 150 kHz to 80 MHz, with 80% amplitude modulation at 1 kHz) can increase by +/- (0.08% of
range) at the frequency range of 20 - 50MHz. (IEC 61000-4-6).
6
Performance Criterion C applied at the 70%/25 cycle Voltage-Dip and the 0%/250 cycle Voltage-Interruption test
levels (IEC 61000-4-11).
7
Instrument rebooting may be experienced where the EUT takes approximately 18 seconds to recover from IEC
61000-4-11 transient immunity test.
1-8
EMC requirements for electrical equipment for
1, 2, 3
AC power line harmonic emissions.
Voltage changes, fluctuations, and flicker.
4
5
6, 7