Safety Compliance - Tektronix DMM4040 User Manual

Australia / New Zealand Declaration of Conformity – EMC
Complies with the EMC provision of the Radiocommunications Act per the following
standard, in accordance with ACMA:
CISPR 11:2003.
with EN 61326-1:2006 and EN 61326-2-1:2006.

Safety Compliance

EC Declaration of Conformity – Low Voltage
Compliance was demonstrated to the following specification as listed in the Official
Journal of the European Communities:
Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
U.S Nationally Recognized Testing Laboratory Listing
ISA-82.02.01. Safety Standard for Electrical and Electronic Test, Measuring,
Controlling and Related Equipment -- General Requirements.
Canadian Certification
CAN/CSA-C22.2 No. 61010-1:2004.
equipment for measurement, control, and laboratory use. Part 1.
Additional Compliances
IEC 61010-1: 2001.
measurement, control, and laboratory use.
ANSI/UL 61010-1:2004, 2nd Edition. Standard for electrical measuring and
test equipment.
Equipment Type
Test and measuring.
Safety Class
Class 1 — grounded product.
Pollution Degree Description
A measure of the contaminants that could occur in the environment around and within a
product. Typically the internal environment inside a product is considered to be the same
as the external. Products should be used only in the environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Radiated and Conducted Emissions, Group 1, Class A, in accordance
Safety requirements for electrical equipment for
Introduction and Specifications
Safety requirements for electrical
Compliance Information
1
1-9