Environmental Considerations; Product End-Of-Life Handling - Tektronix DMM4040 User Manual

DMM4040/4050
Users Manual
Pollution Degree
Pollution Degree 2 (as defined in IEC 61010-1). Note: Rated for indoor use only.
Measurement Overvoltage Categories
CAT I – 1000V / CAT II – 600V

Environmental Considerations

This section provides information about the environmental impact of the product.

Product End-of-Life Handling

Observe the following guidelines when recycling an instrument or component:
Equipment Recycling
Production of this equipment required the extraction and use of natural resources. The
equipment may contain substances that could be harmful to the environment or human
health if improperly handled at the product's end of life. In order to avoid release of such
substances into the environment and to reduce the use of natural resources, we encourage
you to recycle this product in an appropriate system that will ensure that most of the
materials are reused or recycled appropriately.
This symbol indicates that this product complies with the applicable European Union
requirements according to Directives 2002/96/EC and 2006/66/EC on waste electrical
and electronic equipment (WEEE) and batteries. For information about recycling options,
check the Support/Service section of the Tektronix Web site (www.tektronix.com).
Restriction of Hazardous Substances
This product has been classified as Monitoring and Control equipment, and is outside the
scope of the 2002/95/EC RoHS Directive.
Perchlorate Materials
This product contains one or more type CR lithium batteries. According to the state of
California, CR lithium batteries are classified as perchlorate materials and require special
handling. See www.dtsc.ca.gov/hazardouswaste/perchlorate for additional information.
1-10
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution that
becomes conductive due to condensation. These are sheltered locations where
neither temperature nor humidity is controlled. The area is protected from direct
sunshine, rain, or direct wind.
Pollution Degree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.