Introduction - Tektronix DMM4040 User Manual

Introduction

The Meter can be controlled either by sending commands through one of its
communication interfaces or by manually operating its front panel controls. This chapter
explains the function and use of the controls and indicators located on the front and rear
panels of the Meter. Operating the Meter through its computer interfaces is covered in the
Programmers Manual. The following features are not available in OutGuard SW versions
earlier than 2.0: DCI with DCV dual-function, DCV Ratio, 400 mA range, and digital
filter. Also, the function softkey positions for earlier releases are slightly different than
illustrated.
To view the OutG SW version:
1. Press I
2. Press the softkey labeled SYSTEM.
3. Press the softkey labeled VERSION.
Front-Panel Operation

Introduction

3
3-3