Using Dc Output - Hyundai HCP9000 User Manual

4.6 Using DC Output Terminals
You can use 12V 8.3A DC output to charge automotive batteries. Be sure to
monitor the battery charge time.
Over-charge may cause explosion and injury
1. Connect the positive (red) terminal of the battery to the red (positive)
terminal the 12V 8.3A DC Output Terminal on the front panel
2. Connect negative(black) terminal of the battery to the black (negative)
terminal of the 12V 8.3A DC Output terminal on the front panel (DO NOT
REVERSE POLARITY OF CONNECTIONS)
3. Start the generator according to section 4.3
An explosive hydrogen gas is discharged through vent holes in the battery
during charging. Do not allow sparks or open flames around the generator or
battery during the charging process.
Electrolyte fluid can burn eyes and clothing. Be extremely careful to avoid any
contact. If injured, wash the affected area immediately with large amounts of
water and seek medical attention immediately.
When charging a large capacity battery or totally discharged battery, excessive
current may force the DC breaker to turn off. In this case, use a battery charger.
GROUND FAULT CIRCUIT INTERRUPTER RECEPTACLE
This receptacle is protected by the GFCI for protection against electrical shock.
Using the generator in rain, snow, or in water can lead to electrical shock.
Always keep your generator dry and away from any water sources.
25