GASOLINE POWER GENERATORS Basic HY3000I HY6000I HY7000I HY9000I Economic HY2500 HY3100 HY6000 HY7000 HY9000 HY2500L(S) HY3100L(S)(E) HY6000L(S)(E) Professional HY7000L(S)(E)-(3) HY9000L(S)(E)-(3) USER MANUAL CHECK CAREFULY THIS USER MANUAL IN ORDER TO AVOID INJURIES MADE UNDER LICENSE OF HYUNDAI CORP. SEOUL, KOREA...
SAFETY INFORMATION Before use of the machine please read carefully this manual Any use of the generator without reading this manual could cause hard damage to the machine o can hurt yourself seriously Pay special attenction to the next: • Do not use the generator in a non ventilated area •...
CHECK BEFORE USE Control the oil level when the unit is off. Take the dipstick and wipe with a clean cloth. Place the dipstick without turning. Check the level on the dipstick mark If the level is below the mark, fill to the mark Screw the dipstick Fuel level Open the fuel cap of the fuel tank...
START OF THE ENGINE Before start the engine, do not connect to device. Place the fuel valve on "ON" Place the starter in position "OPEN" Set switch to "ON" MANUAL START: Slowly pull the starter until it becomes "harder" then yank. 5b.
STOP THE ENGINE Turn off power connected to the generator Set the switch to "OFF" Turn the fuel valve to "OFF" Note In case of emergency to stop your group's position switch to "OFF" MAINTENANCE It is very important to effecuer following maintenance controls and to ensure the proper functioning of your group.
Page 8
MAINTENACE Replace engine oil Unscrew and remove the dipstick Unscrew the drain plug and drain the oil in the crankcase. Tighten the drain plug after drained. Fill the crankcase until the maximum level gauge Reposition the dipstick and tighten. It is recomend to run the engine for 15min before replace the oil Oil tipe: 4-stroke gasoline engine oil recommended SAE 10W-30 Air Filter...
Page 9
MAINTENANCE SPARK PLUG Disconnect the spark plug cable Unscrew and remove the spark plug housing Clean the spark plug with a wire brush Check the electrode gap Screw the spark plug and its connect cable Spark plu type: F6RTC or F7RTC FUEL FILTER Position fuel valve to "OFF"...
PROBLEM/SOLUTIONS CASE SOLUTION - No oil in the engine - Oil level is too low - Main switch in not in on position positionner l'interrupteur principal sur "ON" The Engine does not start - Fuel valve close/not fuel - Open the fuel valve, fill fuel in the fuel tank - Check ignition coil and spark plug - There is no ignition...