WARNING
For continuous operation, do not exceed the
●
rated out-put power of generator.
Do not make parallel connection with other
●
generators.
Do not connect an extension to the exhaust
●
pipe.
When an extension cable is required, be sure
●
to use a tough rubber sheathed flexible cable
(according to IEC245 or equivalent
standards). The maxmin length of the
extension cable: 60m for cable of 1.5mm ;
100m for cable of 2.5mm .
2
Keep away from other electric cables or wires.
●
NOTE
The
receptacle can be used while the
■
DC
power is in use. If use both at same time, be
sure not to exceed the total power for
DC.
Most of motor appliances require more than
■
their rated wattage, when starting.
6.1) DC Application
The DC receptacle, 15-30V under no-load condition,
may be used for charging 12V battery only.
NOTE
In DC operation, turn the
■
"OFF" ( ) position.
6.1.1) Disconnect the vehicle battery ground cable
from the negative
6.1.2) Connect the DC
terminals with the charging cable
CAUTION
2
Connect red lead to positive
and black lead to negative
6.1.3) Turn
ECON. SW
then start engine
AC
and
AC
ECON. SW
to the
battery terminals.
(-)
terminals
to battery
.
battery terminal
(+)
battery terminal.
(-)
to "OFF" ( ) position and
,
.
<<19>>