Maintenance Instructions - Stamina Inversion Table Owner's Manual

STORAGE
FOLDING THE INVERSION TABLE
The
To fold the
HEIGHT ADJUSTMENT BEAM(6)
Now, slide the
ADJUSTABLE INSTEP FRAME(7)
PIN(16)
and slide the
the beam in place. Remove the
FRAME(4)
until the
NYLON STRAP
(Make sure the
Push up on the center of the
FRAME(2)
together until they meet.

MAINTENANCE INSTRUCTIONS

The safety level of the
wear.
1. Check the nylon strap, strap buckle, pivot arms, nylon bed, heel holders, small spring pin and large
spring pin for damage and wear.
2. Replace damaged and worn components immediately and/or keep the equipment out of use until repair.
can be easily folded for storage.
LOCKING KNOB(17)
loosen
is just below the
HEIGHT ADJUSTMENT BEAM(6)
MAIN FRAME ASSEMBLY
PIVOT ARMS(5)
come out of the slots located at the top of the
is not attached to the
FOLDING LINKAGES(3)
can be maintained only if it is examined regularly for damage and
and pull out the
all the way up into the
MAIN FRAME(4),
slightly up or down until the spring pin locks
from the
MAIN FRAME(4)
and push the
13
LARGE SPRING PIN(16).
MAIN FRAME(4)
LARGE SPRING
release the
BASE
by lifting up on the
REAR FRAME(2),
before attempting to remove it.)
FRONT FRAME(1)
until the
MAIN
REAR
and