Stamina Inversion Table Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
STEP 3
Slide the bottom of the two
Align the desired hole on the arm with the peg on the bracket, and insert the peg into the hole to lock the
PIVOT ARMS(5)
in position.
BOLTS(M6 x 8mm)(43) and LARGE WASHERS(M6)(42).
PIVOT ARM ADJUSTMENT:
There are three adjustment holes on the
at three different heights. The lowest hole will allow the least amount of inversion angle. The top hole will
allow the greatest amount of inversion angle.
CAUTION:
1. Use the lowest holes in the
2. Both
ARMS(5)
STEP 4
MAIN FRAME(4)
Attach the
ARMS(5)
into the slots on the
PIVOT ARMS(5)
Then secure the PIVOT ARMS(5) on the pegs with BUTTON HEAD
PIVOT ARMS(5)
.
PIVOT ARMS(5)
must be adjusted to the same hole. Trying to adjust the
to different positions could cause damage to the machine, and injury to the user.
REAR FRAME(2)
onto the
REAR FRAME(2)
SLOTS
into the brackets located at each side of the
allowing you to position the
PIVOT ARMS(5)
by sliding the slots in the ends of the two
.
7
MAIN FRAME(4).
MAIN FRAME(4)
until you become familiar with the
PIVOT
PIVOT