Stamina Inversion Table Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
BUCKLE
1.
2.
BUCKLE
STEP 8
HEIGHT ADJUSTMENT BEAM(6)
Install the
PIN(16) MAIN FRAME(4)
on the
added safety, thread the
WARNING:
Do not use the
the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT
STEP 9
NYLON STRAP(25)
Attach the
the end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 10
NYLON STRAP(25)
Hook the end of the
BUCKLE STRAP(26)
end of the
NYLON STRAPS
NOTE: The
a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps.
Make sure these
before using the
A.
B.
C.
and inserting the
LOCKING KNOB(17)
instructions on page 10.
BUCKLE
onto the
onto the loop on the back of the
onto the loop on the
are used to control the decline angle of the
NYLON STRAPS
MAIN FRAME(4)
into
HEIGHT ADJUSTMENT BEAM(6)
into back side of the
until you have verified your height setting. Failure to use
on the end of the
FRONT FRAME(1).
are tight in the buckle and check the decline angle
.
9
LARGE SPRING
by pulling the
MAIN FRAME(4).
BUCKLE STRAP(26)
MAIN FRAME(4).
as shown. For
by inserting
Hook the
.
For