Stamina Inversion Table Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 5
FOOTREST(8)
Attach the
WASHERS(M8)(38),
NOTE: The five holes in the
positions. Start with the center position and adjust if necessary. Use the outer position if users are
taller than average. Use the inner position if users are shorter than average.
STEP 6
PAD TUBE(9)
Insert the
BOLT(M6 x 45mm)(32)
HEEL HOLDER(11),
a
BRACKET(10)
and
STEP 7
ADJUSTABLE INSTEP FRAME(7)
Attach the
SMALL SPRING PIN(13)
the
HEIGHT ADJUSTMENT BEAM(6).
HEIGHT ADJUSTMENT BEAM(6),
tube on the
SPRING(12),
slide the bolt through the square tube and secure with
SQUARE PLUG(40)
BRACKET(10)
and
HEIGHT ADJUSTMENT BEAM(6)
onto the
NYLOCK NUTS(M8)(36).
and
FOOTREST(8)
through the hole on the
NYLOCK NUT(M6)(35).
and
then slide them onto
HEEL HOLDER(11)
and sliding the
Insert the
HEIGHT ADJUSTMENT BEAM(6).
into the
HEEL HOLDER(11)
FOOTREST(8)
allow the
HEIGHT ADJUSTMENT BEAM(6)
Place a
PAD TUBE(9)
together. Slide another set of
over the other end of the
HEIGHT ADJUSTMENT BEAM(6)
to the
ADJUSTABLE INSTEP FRAME(7)
BOLT(M6 x 45mm)(32)
slide the bolt through the ring at the bottom of the
onto both sides of the
8
BOLTS(M8 x 50mm)(34),
with
to be attached in three different
HEEL HOLDER BRACKET(10)
PAD TUBE(9).
halfway through the square
NYLOCK NUT(M6)(35).
Install a
ADJUSTABLE INSTEP FRAME(7).
and secure with
onto
HEEL HOLDER
by pulling
completely into the
Press the
HEEL HOLDER