Stamina Gravity Inversion Table Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
BUCKLE
1.
2.
STEP 8
HEIGHT ADJUSTMENT BEAM(6)
Install the
PIN(18) MAIN FRAME(4)
on the
added safety, thread the
WARNING:
Do not use the
to use the proper height setting can result in difficulty recovering from the decline position.
HEIGHT ADJUSTMENT
See
STEP 9
NYLON STRAP(27)
Attach the
the end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 10
NYLON STRAP(27)
Hook the end of the
BUCKLE STRAP(28)
end of the
NOTE: NYLON STRAPS
The
For a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps.
Make sure these
Gravity Inversion Table.
using the
A.
B.
C.
and inserting the
LOCKING KNOB(19)
Gravity Inversion Table
BUCKLE
onto the
onto the loop on the back of the
onto the loop on the
are used to control the decline angle of the
NYLON STRAPS
MAIN FRAME(4)
into
HEIGHT ADJUSTMENT BEAM(6)
into back side of the
until you have verified your height setting. Failure
instructions on page 10.
on the end of the
FRONT FRAME(1).
are tight in the buckle and check the decline angle before
9
LARGE SPRING
by pulling the
MAIN FRAME(4).
BUCKLE STRAP(28)
MAIN FRAME(4).
Gravity Inversion Table.
as shown. For
by inserting
Hook the