Stamina Gravity Inversion Table Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 5
FOOTREST(8)
Attach the
KNOB(9).
NOTE:
The four adjustment holes in the
different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.
STEP 6:
Insert the
HEX BOLT(M6 x 47mm)(40), NYLOCK NUT(M6)(42),
secure with
HEEL HOLDER BRACKET(11)
a
together. Slide another set of
PAD TUBE(10).
end of the
STEP 7:
Attach the
SMALL SPRING PIN(15)
by pulling the
HEIGHT ADJUSTMENT BEAM(6).
into the
(M6 x 47mm)(40),
then insert the bolt the halfway through the square tube on the
BEAM(6),
slide the bolt through the ring at the bottom of the
square tube and secure with
PLUG(35)
into the
HEEL HOLDER(12)
and
HEIGHT ADJUSTMENT BEAM(6)
onto the
PAD TUBE(10)
through the hole on the
onto a
HEEL HOLDER BRACKET(11)
ADJUSTABLE INSTEP FRAME(7)
NYLOCK NUT(M6)(42)
HEIGHT ADJUSTMENT BEAM(6).
onto both sides of the
FOOTREST(8)
allow the
HEEL HOLDER(12),
to the
ADJUSTABLE INSTEP FRAME(7)
and sliding the
WASHER(M6)(45)
Place a
WASHER(M6)(45).
and
Install a
ADJUSTABLE INSTEP FRAME(7).
8
with the
FOOTREST(8)
HEIGHT ADJUSTMENT BEAM(6)
WASHERS(M6)(45).
and
then slide them onto
HEEL HOLDER(12)
and
HEIGHT ADJUSTMENT BEAM(6)
onto the
HEIGHT ADJUSTMENT
SPRING(13),
slide the bolt through the
HEEL HOLDER BRACKET(11)
ADJUSTMENT
to be attached in four
and
Place
PAD TUBE(10)
over the other
completely
HEX BOLT
SQUARE
Press the