Transmission Fluid Change - KYMCO PEOPLE 50 Owner's Manual

MAINTENANCE

Transmission fluid change

1. Place the scooter on its main stand.
2. Place a suitable container (drain pan) under the transmis-
sion case on its left side. Remove the drain bolt
drain the fluid.
3. After the fluid has drained out, reinstall the drain bolt with a
new sealing washer and tighten it to the specified torque.
Transmission fluid drain bolt torque: 15 lb-ft (20 N-m)
4. Remove the transmission fluid filler bolt from the filler
hole 2.
5. Add the exact specified fluid through the fluid filler hole.
Only fill the transmission so the fluid level stays below
the filler hole 3.
3 3 3 3 3
2 2 2 2 2
1 1 1 1 1
Transmission fluid type:
Transmission fluid capacity (50):
Transmission fluid capacity (150):
NOTE: The fill amount specified is the amount to use after
completely draining the used transmission fluid.
Do not exceed the specified amount when adding trans-
mission fluid. If too much fluid is added to the trans-
mission case, it could be forced into the air cleaner as-
sembly during operation, causing air filter contamina-
1 to
tion and poor engine performance.
Using the wrong transmission fluid type or viscosity
may cause premature transmission component wear.
SAE 90
0.13 qt (0.12 L)
0.25 qt (0.21 L)
45