Transmission Fluid Change - KYMCO People S 250 Owner's Manual

MAINTENANCE
F
L
7. Remove the dip stick and visually inspect the oil level on the
stick. The engine oil level should be above the "L" mark
but not higher than the "F" mark. Add or remove oil as
required.
Do not overfill the engine with oil. Overfilling the en-
gine can cause oil leaks and/or oil contamination of
the air filter element. Always make sure the oil level is
above the "L" mark but not higher than the "F" mark
on the dipstick.
8. Replace the oil filler/dipstick and tighten it securely.
4 4 4 4 4

Transmission fluid change

1. Place the scooter on its main stand.
2 2 2 2 2
1 1 1 1 1
2. Place a suitable container (drain pan) under the transmis-
sion case on its left side. Remove the drain bolt 1 to
drain the fluid.
3. After the fluid has drained out, reinstall the drain bolt with a
new sealing washer and tighten it to the specified torque.
Transmission fluid drain
bolt torque:
4. Remove the transmission fluid filler bolt from the filler
hole 2.
5. Add the exact specified fluid through the fluid filler hole.
Only fill the transmission so the fluid level stays below
the filler hole opening.
15 lb-ft (20 N-m)
NOTE: Procedure continued on next page.
47