Connecting Via An Ethernet Cable; Connecting Wirelessly - NetComm FIBRE NF1ADV User Manual

WiFi Data and VoIP Gateway
NF1ADV
Hardware installation
1. Insert an Ethernet LAN cable from the WAN port of the NF1ADV to a LAN port on your modem/switch/hub.
2. For VoIP functionality, connect a standard analogue telephone to one or both of the FXS ports labelled Phone 1 or Phone 2
using the RJ-11 Cable provided.
3. For PSTN pass-through connect an RJ-11 cable from any wall jack to the FXO Line port of the NF1ADV.
4. Connect the power adapter to the Power socket on the back of the NF1ADV.
5. Plug the power adapter into the wall socket and switch on the power.
6. Wait approximately 60 seconds for the NF1ADV to power up.

Connecting via an Ethernet cable

1. Connect the Ethernet cable provided to the port marked LAN at the back of the NF1ADV.
2. Connect the other end of the yellow Ethernet cable to your computer.
3. Wait approximately 30 seconds for the connection to establish.
4. Open your Web browser and type http://192.168.1.1 into the address bar and press enter.
5. Enter "admin" (without quotations) for both the Username and Password and click on the Login button.
6. Follow the steps of the start-up wizard to set up your NF1ADV.
7. After the setup process is completed, you will be connected to the Internet.

Connecting wirelessly

1. Ensure WiFi is enabled on your device (computer/laptop/Smartphone).
2. Scan for wireless networks in your area and connect to the network name that matches the Wireless network name found
on the Wireless Security Card (included in the box).
Please note: For security purposes, each NF1ADV has a unique SSID (such as NetComm Wireless XXXX) and Wireless
Security Key. The included Wireless Security Card lists these fields instead of the xxxxx's as shown in the screenshot
above.
3. When prompted for your wireless security settings, enter the wireless security key listed on your Wireless Security Card.
4. Wait approximately 30 seconds for the connection to be established.
5. Open your Web browser and type http://192.168.1.1 into the address bar and press enter.
6. Enter "admin" (without quotations) as both the Username and Password and press the Login button.
7. Follow the steps to set up your NF1ADV.
8. After the setup process is completed, you will be connected to the Internet.
9. To connect additional devices via WiFi, repeat steps 1 through 4.
YML27
www.netcommlimited.com
Figure 2 - Included Security Card
NF1ADV User Guide
12