Physical Dimensions And Indicators; Led Indicators - NetComm FIBRE NF1ADV User Manual

Physical Dimensions and
Indicators

LED Indicators

The NF1ADV has been designed to be placed on a desktop. All of the cables exit from the rear for better organization. The display is
visible on the front of the NF1ADV to provide you with information about network activity and the device status. See below for an
explanation of each of the indicator lights.
LED INDICATOR
Power
LAN
WAN
WiFi
WPS
Phone1
Phone 2
Line
DSL
WWW
DECT
Page Register
NF1ADV User Guide
7
ICON
The power LED will be a solid green light when the device is powered
on. The power LED will flash during the device start up process.
The LAN LEDs will be a solid green light when a specific LAN
connection is established. The LED flashes on LAN port traffic
throughput.
WAN mode: The WAN LED lights up when the router is connected to
the internet via an Ethernet WAN connection.
The LED will show a solid green light when WLAN is enabled. The LED
flashes on traffic throughput (data transfer).
The WPS LED will light up to indicate that the wireless signal has been
configured using the WiFi Protected Setup option.
A solid blue light appears when the analogue telephone connected to
Line 1 is off-hook. The Line 1 LED will flash on an incoming call.
A solid green light appears when the analogue telephone connected to
Line 2 is off-hook. The Line 2 LED will flash on an incoming call.
The Line LED will be on when a line cable for PSTN calls is connected
from the router to a phone port of an ADSL filter.
The DSL LED will flicker on and off when training for a DSL signal.
When a DSL signal is detected the LED will be a solid green light.
The WWW LED will light up when there is a WAN connection through
a fixed DSL connection.
The DECT LED will light up when the NF1ADV is DECT registration
mode
This Icon will light up when a DECT phone connected to the router is
off hook. It will also flash on an incoming call.
Table 2 - LED Indicators
DEFINITION
www.netcommlimited.com
YML38