Internal Link Options - ALLEN & HEATH GL2200 User Manual

INTERNAL LINK OPTIONS

The console is set to satisfy most applications that should be encountered. However, the following
internal link options are offered to provide alternative settings for those applications that may require
them. These options involve resoldering of circuit board links and should only be carried out by
competent technical personnel. Further information is available in the GL2200 SERVICE MANUAL
and from your agent.
MONO & STEREO INPUT
1. Reconfigure each aux as required to be permanently pre-fade or post-fade rather than
switched by the front panel PRE switch.
2. Reconfigure the pre-fade sends to be pre-EQ / pre-mute, or post-EQ / pre-mute, instead
of the standard post-EQ / post-mute.
3. Disable +48V phantom power regardless of panel switch position - remove link.
4. Reconfigure the Direct Out Source to be pre-fade or post-fade.
MONO
STEREO
AUX 6
CUT LINKS
INSERT IC
SSM2142
AUX 5
CUT LINKS
INSERT IC
SSM2142
CONNECTOR
LEFT & CONNECTOR
For Aux out 5 & 6 balance option with
jack output tip = hot, ring = cold. Remove
two links and plug in balance driver IC.
AUX 2/4
CUT LINKS
INSERT IC
SSM2142
GROUP
AUX 1/3 For Aux out 1-4 balance option with jack
CUT LINKS
INSERT IC
output tip = hot, ring = cold. Remove two
SSM2142
L22 GROUP
AG3425
links and plug in balance driver IC.
GROUP
GL2200 U G
SER UIDE
L22 STEREO
AG3428
LEFT
L22 LEFT
AG3426
25