This section allows you to configure Static Routes –
•
Route no: Enter a number for your route
•
Route Name: Enter a name for your route
•
Destination IP address: Enter the destination IP address for your route
•
IP subnet mask: Enter the subnet mask for your route
•
Gateway IP Address: Enter the default gateway IP address for your route
•
Metric: Enter a metric for your route. The lower metric value routes get preference over higher metric value routes.
Once you have entered the above parameters, click on the 'Add' button to add the static route. You should now see your route as a static route table entry.
4.4.3. Routing RIP
This section allows you to enable a Dynamic Routing Protocol. The dynamic routing protocols supported on your MyZone are the RIP version 1 and RIP
version 2. RIP or Routing Information Protocol is a dynamic routing protocol used in local and wide area networks.
To enable RIP, follow these steps –
RIP Enable: Click on 'enable' to turn on RIP
Version: RIP has 2 versions – 1 or 2. Version 1 is the older dynamic routing protocol based on Class based IP addressing. Version 2 is the newer version of
RIP that understands Classless IP addressing. It is highly recommended that you use Version 2 of RIP.
Once you have completed your settings, click on 'Save RIP' to store the settings.