Table of Contents
Advertisement
2.7 Getting Online in 5 Minutes
Note: Please ensure you charge your MyZone fully for at least 8 hours before using it without the USB cable connected to a power source.
1.
Insert your SIM (and connect the USB cable to a power source if the battery is running low). Power on the MyZone by sliding down the power switch
until the power status light illuminates.
2.
On your Laptop/Computer/Smartphone/iPhone, scan for the following wireless network name (SSID) – "NetComm MyZone."
3.
Connect wirelessly to the MyZone using "password" as your initial security key.
4.
Don't forget to personalize the SSID and the security key of your MyZone from the defaults to help ensure security on your network. Open your browser
and type http://my.zone into the location bar to bring up the Myzone Configuration Manager where you can configure the 3G, WiFi and router settings
of your MyZone as well as advanced status information.
5.
Authentication can be achieved via the MyZone Configuration Manager using the default User Name and Password (admin/admin) and click submit.
If successful the MyZone Configuration Manager will appear in your browser as shown below.
6.
Click on the 'Wireless' tab to configure your wireless security settings. In the field SSID enter your new name. In the field WPA Pre-Shared Key enter
your new personalized security key. Choose a mix of upper and lower case letters as well as numbers to compose a strong security key. Confirm the
new key in the second field and click the 'Save' button to save your new settings.
Note: Inserting or removing the SIM card from the unit while it is ON will reboot your MyZone.
YML24W-RAU
www.netcomm.com.au
NETCOMM LIBERTY SERIES - MyZone Mobile 3G WiFi Router
MyZone User Guide
11
Advertisement
Table of Contents
