Table of Contents
Advertisement
Advanced Setup > Routing
Advanced Setup > Routing > Default Gateway
The Enable Automatic Assigned Default Gateway checkbox is ticked by default. The router will accept the first
received Default Gateway assignment from one of the PPPoA, PPPoE or MER/DHCP enabled PVC(s).
Advanced Setup > Routing > Static Route
Use this if your LAN consists of multiple subnets and you want to manually define the data transmitting paths
To create a new Static Route, click Add. The Routing-Static Route Add page will shows up.
The key settings for adding a new Static Route are explained:
Destination Network Address
Subnet Mask
Use Gateway IP Address
Use Interface
Click Save/Apply to take effect the settings. To delete an entry from the list, click its corresponding Remove button.
Advanced Setup > Routing > RIP
YML901 Rev1
www.netcomm.com.au
Enter the network address to which the data packets are to be sent.
Enter the subnet mask for this destination.
If you wish to use a specific gateway to reach the destination network, select this
checkbox and then enter the IP address of the gateway.
If you wish to use a particular WAN interface, select the checkbox and select the interface.
NB7 Series
NB7 Series User Guide
NB7 Series User Guide
Advertisement
Table of Contents
