Table of Contents
Advertisement
Routing
Static
Static routing is the alternative to dynamic routing used in more complex network scenarios and is used to facilitate communication
between devices on different networks. Static routing involves configuring the routers in your network with all the information
necessary to allow the packets to be forwarded to the correct destination. If you change the IP address of one of the devices in the
static route, the route will be broken.
Some routes are added by default by the router on initialization such as the Ethernet subnet route for routing to a device on the
Ethernet subnet.
Adding Static Routes
To add a new route to the static routing list, click the +Add button. The Static routes page appears.
1.
In the Route name field, type a name for the route so that it can be identified in the static routing list.
2.
From the Network interface drop down list, select the interface for which you would like to create a static route.
3.
In the Destination IP address field, enter the IP address of the destination of the route.
4.
In the IP subnet mask field, enter the subnet mask of the route.
5.
In the Gateway IP address field, enter the IP address of the gateway that will facilitate the route.
6.
In the Metric field enter the metric for the route. The metric value is used by the router to prioritise routes. The lower the
value, the higher the priority. To give the route the highest priority, set it to 0.
7.
Click the Save button to save your settings.
NetComm Wireless NTC-30WV 3G Outdoor Router with Voice
46
Figure 45 - Static routing list
www.netcommwireless.com
Advertisement
Table of Contents
