Burner Identifi Cation/Verifi Cation - Heat & Glo 6000CLX-IPI-T Owner's Manual

Note: The base refractory must be
removed to access screws.
BASE REFRACTORY
Figure 3.5 Base Refractory Removal
Figure 3.7 Burner Identifi cation
16 Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
Figure 3.6 Valve Assembly Removal
D. Burner Identifi cation/Verifi cation
The burner may be accessed for identifi cation and veri-
fi cation purposes. This task should be performed by a
qualifi ed service technician. The base refractory, valve
plate, refractory and grate do not need to be removed to
access the burner assembly. The logs and fi ber burner
top need to be removed to access the burner. Disconnect
the pilot from the burner before removal. See Figure 3.7
for burner identifi cation chart. Notch patterns are located
on bottom side of burner.
NOTCH LOCATION
NG
6000C
6000CL
6000CLX
6000CBV
8000C
8000CL
8000CLX
8000CBV
LP