Refractory Installation - Heat & Glo 6000CLX-IPI-T Owner's Manual

F. Refractory Installation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation.
CAUTION! Refractory is fragile. Handle with care.
Step 1. Back Refractory Panel Installation
The back refractory panel has a rectangular notch on the
bottom side.
1. Hold the back refractory panel with the notch on the
bottom facing down.
2. Place the back refractory panel against the back of the
fi rebox. Ensure back refractory panel makes full contact
with the back wall of the fi rebox. See Figures 1 and 2.
BACK WALL OF FIREBOX BACK WALL OF FIREBOX
EXPANSION BAR EXPANSION BAR
8000 MODELS ONLY 8000 MODELS ONLY
DO NOT REMOVE DO NOT REMOVE
Figure 1
Figure 2
Step 2. Right Refractory Panel Installation
The right refractory panel has a rectangular notch on the
bottom side.
3. Place the right refractory panel against the right side-
wall of the fi rebox. Rest the rectangular notch located
on the bottom of the right refractory panel over the
lower fi rebox lip. Let refractory foot rest on fi rebox af-
ter panel's notch has been mated with fi rebox lip. See
Figure 3.
58 Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
REFRACTORY REFRACTORY
FOOT FOOT
LOWER LOWER
FIREBOX LIP FIREBOX LIP
Figure 3
4. Slide the right refractory panel completely into the fi re-
box until it securely rests against back refractory panel.
Make sure that right refractory panel makes full contact
with the right sidewall of the fi rebox. See Figure 4.
Figure 4
5. Verify that right refractory panel is slid all the way back
by looking to see that it's fl ush with the fi rebox lip.
NO GAPS NO GAPS
Figure 5
NOTCH NOTCH
REFRACTORY REFRACTORY
PANEL MUST PANEL MUST
BE FLUSH WITH BE FLUSH WITH
LOWER FIREBOX LOWER FIREBOX
LIP LIP