Heat & Glo 6000CLX-IPI-T Owner's Manual page 63

Models: 8000CLX-IPI-S, 8000CLX-IPILP-S,
8000CLX-IPI-T, 8000CLX-IPILP-T
LOCATING HOLES
FIBER BURNER TOP
BURNER SHIELD
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 1
CAUTION: Logs are fragile, handle with care. Log #1 (2170-701): Locate log placement tabs on the pilot cover (see Figure
2). Locate log placement slots on the bottom of Log #1 (see Figure 3). Mate slots located on the bottom of Log #1 with the
log placement tabs on the pilot cover. Log #1 is properly installed when it sits squarely and completely on the pilot cover
with log placement tabs engaged (see Figure 4).
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
Figure 3
Figure 4 shows the log placement pins located on the top of Log # 1. The pins will be mated with the pin holes located on
the bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated
properly on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.
Bottom view of Bottom view of
Logs # 2 and 3 Logs # 2 and 3
3 3
Figure 5
Log #2 (2170-702): Mate the pin hole located on the bottom of Log #2 with the left log placement pin on top of Log #1.
After pin hole and pin have been fi tted together, mate the groove located on the bottom of Log #2 with the horizontal grate
bar and slide Log # 2 toward the left until it rests against the far left grate tine.
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
TAB BENT IN = NG
PILOT COVER
TAB NOT BENT = LP
PIN HOLES PIN HOLES
2 2
GROOVES GROOVES
Log Assembly: LOGS-8CLX
LOG PLACEMENT TABS LOG PLACEMENT TABS
GRATE TINE GRATE TINE
LOG PLACEMENT INDENTATIONS LOG PLACEMENT INDENTATIONS
Figure 2
LOG PLACEMENT PINS LOG PLACEMENT PINS
Figure 4
LEFT GRATE TINE LEFT GRATE TINE
2 2
Figure 6
1 1
1 1
63