Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo 6000CLX-IPI-T Owner's Manual

14 14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 14.J.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
E. Burner Top Installation
1. Remove and retain the two screws holding the pilot
cover in place.
2. To install the fi ber burner, mate the locating holes with
the guide sleeves. Install fi ber burner top so that it
makes full contact with the underlying burner assem-
bly.
3. Reinstall the pilot cover using the two screws removed
in step 1.
4. Ensure that the ports in the steel burner are visible
through the holes in the fi ber burner top.
FIBER BURNER TOP
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 14.1
LOCATING HOLES
PILOT COVER
BURNER SHIELD
57