Heat & Glo 6000CLX-IPI-T Owner's Manual page 64

2 2
HORIZONTAL GRATE BAR HORIZONTAL GRATE BAR
Figure 7
Log #3 (2170-703): Mate the pin hole located on the bottom of Log #3 with the right log placement pin on top of Log #1.
After pin hole and pin have been fi tted together, mate the groove located on the bottom of Log #3 with the horizontal grate
bar and far right grate tine. Log #3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7).
Log #4 (2170-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to left
under Log #2 to fi t completely and securely into the indentation (see Figure 8). Nose of log #4 should be pulled to fi t securely
against right hand side of log indentation.
FLAT AREA FLAT AREA
2 2
4 4
Figure 9
Log #5 (2170-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log fi ts completely
and securely in the recessed indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.
Log #6 (2170-706): Mate the groove located on the lower end of Log #6 with the fourth grate tine (from left to right) as shown
in Figure 10. Set the other end of Log #6 on the fl at area located on top of Log #4 (see Figure 9). Log #6 will also rest against
center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing movement or shifting.
2 2
4 4
LOG CONTACTS GRATE TINE LOG CONTACTS GRATE TINE
Figure 11
64 Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
RIGHT GRATE TINE RIGHT GRATE TINE
1 1
3 3
1 1
3 3
5 5
1 1
3 3
7 7
5 5
6 6
2 2
4 4
Figure 8
LOG #6 CONTACTS TOP OF LOG #4 LOG #6 CONTACTS TOP OF LOG #4
2 2
4 4
LOG CONTACTS GRATE TINES LOG CONTACTS GRATE TINES
Figure 10
Log #7 (2170-707): Place back (unnotched) end of Log #7
on the fl at area on the top of Log #5. Log #7 must be pulled
tight to the locating notch. Pivot the front (notched) end of
Log #7 to the right until the notch of Log #7 contacts the
grate tine located 4th from the left as shown in Figure 11.
NOSE NOSE
1 1
3 3
FLAT AREA FLAT AREA
LOCATING LOCATING
1 1
NOTCH NOTCH
3 3
5 5
6 6
2170-935B