Doors - Heat & Glo 6000CLX-IPI-T Owner's Manual

C. Doors
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed.
DOOR FIT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
MT Hammer
Inside
Overlap
Galleria
Inside
CF Inside
Note: Finishing strips may be used to aid in posi-
tioning of non-combustible facing materials for some
of the facing and door combinations specifi ed in the
table above. They must be removed following fi nishing
work. See Figure 13.7.
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. G • 12/09
FINISH MATERIAL SEE
THICKNESS FIGURE
Any 13.6
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
Any 13.6
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 13.7.
NOTICE: Remove fi nishing strips before fi ring appliance.
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
FINISHING STRIP NOT USED
Figure 13.4 Finishing Material 1 Inch Thick or Less
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
(See Figure 13.7 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL
53