Burner Identifi Cation/Verifi Cation - Heat & Glo 6000CL-IPI-S Owner's Manual

Note: The base refractory must be
removed to access screws.
Figure 3.5 Base Refractory Removal
NOTCH LOCATION
Figure 3.7 Burner Identifi cation
Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. AB • 3/15
BASE REFRACTORY
Figure 3.6 Valve Assembly Removal
D. Burner Identifi cation/Verifi cation
The burner may be accessed for identifi cation and veri-
fi cation purposes. This task should be performed by a
qualifi ed service technician. The base refractory, valve
plate, refractory panels and grate do not need to be re-
moved to access the burner assembly. The logs and fi -
ber burner top need to be removed to access the burner.
Disconnect the pilot from the burner before removal. See
Figure 3.7 for burner identifi cation chart. Notch patterns
are located on bottom side of burner.
NG
6000C
6000CL
6000CLX
6000CBV
8000C
8000CL
8000CLX
8000CBV
Note: Notch location may vary by model.
LP
17