Dmx Control With Id Addressing; Static Color; Auto Programs; Edit Customs - Chauvet ColorAdo 2 Tour User Manual

Operation
Programming (Cont.)
DMX Control With ID
Addressing

Static Color

Auto Programs

Edit Customs

COLORado™ 2 Tour User Manual Rev. 01e
In this mode, the fixtures with the same DMX starting address will respond to the DMX
controller based on the fixture's individual ID address setting. If the user selects ID
address "0", all the fixtures with the same DMX address will respond in unison.
Otherwise, each fixture will follow the control for its particular ID address.
1) Repeat steps 1, 2 and 3 from DMX Control Without ID Addressing.
2) Activate ID Addressing in each fixture:
a) Press <MENU> repeatedly until SET shows, and press <ENTER> to accept.
b) Use <UP> or <DOWN> to select ID, and press <ENTER> to accept.
c) Use <UP> or <DOWN> to select ON, and press <ENTER> to accept.
d) Press <MENU> twice to return to the main level.
The Static Color mode allows for permanent RGBW color mixing without a DMX
controller.
1) Press <MENU> repeatedly until STAT shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired color (Red, Green, Blue, or White).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired color value (0~255).
5) Press <ENTER> to accept.
6) Repeat for the other colors.
7) Use <UP> or <DOWN> to select Strob, and press <ENTER> to accept.
8) Use <UP> or <DOWN> to select the desired frequency (0~20).
9) Press <MENU> twice to return to the main level.
Auto programs allow for dynamic RGBW color mixing without a DMX controller.
1) Press <MENU> repeatedly until AUTO shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (AT. 01~10 or PR.
01~10).
3) Press <ENTER> to accept.
You cannot edit auto programs AT. 01~10. However you can edit PR. 01~10 (see
Edit Customs).
This setting allows the programming of up to 30 scenes for each of the 10 customizable
programs, including colors and effects.
1) Press <MENU> repeatedly until EDIT shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select the desired auto program (PR. 01~10).
3) Press <ENTER> to accept.
4) Use <UP> or <DOWN> to select the desired scene (SC. 01~30).
5) Press <ENTER> to accept.
6) Use <UP> or <DOWN> to select the desired color or effect (Red, Green, Blue,
White, Strobe, Time or Fade)
7) Press <ENTER> to accept.
8) Repeat for the other colors or effects.
9) Press <MENU> to return to the Scene level.
10) Repeat for the other scenes.
11) Press <MENU> to return to the main level once done.
-10- December 11, 2009