Configuration (Dmx); Dmx Personalities; Dmx Control; Loss Of Signal Setting - Chauvet COLORado 2-Quad Zoom IP User Manual

Configuration
(DMX)
DMX
Personalities

DMX Control

Loss Of Signal
Setting
Zoom Limit
Settings
COLORado™ 2-Quad Zoom IP User Manual Rev. 3
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the PERS main level.
2. Select the desired personality (TOUR, TR16, STD.Y, ARC.1, AR1.D, ARC.2, AR2.D,
AR2.S, AR2.Z, or HSV).
·
See the DMX Control Table
select for each personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to DMX main level.
b. Select the starting address (D.001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX DMX
Personality Address
TOUR 501
ARC.1 510
AR1.D
509
AR2.Z 506
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level.
2. Select DERR.
a. Select SAVE to make the product use the last command used when the signal is lost.
b. Select BLAC to turn off the all the LEDs when the signal is lost.
These settings allow you to select the zoom range. Basic zoom (BASE) is the default setting
which allows the zoom to move at full range (000–255) and has no adjustable limit. Position 1
(POS.1) and Position 2 (POS.2) allow you to set limits on how far the zoom moves.
1. Set the zoom range to be used:
a. Go to the SET main level.
b. Select ZOOM.
c. Select BASE, POS.1, or POS.2.
2. Set the limit for zoom range POS.1 or POS.2:
a. Go to the CAL main level.
b. Enter the master access passcode as described in Passcode.
c. When CAL shows, press <UP>.
d. Go to ZOOM.
e. Select POS.1 or POS.2.
f. Select a zoom limit value (000–255).
for the highest recommended starting address you can
DMX Personalities.
DMX DMX
Personality Address
ARC.2 509
AR2.D 508
AR2.S
507
Operation
DMX DMX
Personality Address
HSV 510
STD.Y 496
TR16
496
-15-