Location Requirements; Ups Unpacking And Setup; Three- And Six-Slot Cabinets - Powerware 9170 User Manual

Installation Setup

Location Requirements

Install the Powerware 9170 UPS as close as possible to the equipment or
the load distribution panel it will protect. If this distance is more than
25 ft (7.6m), transient noise can reappear in the electrical distribution
system.
If additional Powerware 9170 system batteries are in a separate cabinet,
the external battery cabinet should be located as close as possible to the
Powerware 9170 UPS. If the batteries will be further from the unit than
the standard cables allow, contact your service representative or your
local distributor for assistance.

UPS Unpacking and Setup

The Powerware 9170 UPS is shipped in a carton on a shipping pallet.
Power and battery modules are shipped in separate boxes on another
pallet. Three-slot cabinets and modules are shipped on one pallet.
To open the UPS carton and remove the UPS from its shipping pallet,
use one of the following procedures. Also refer to the unpacking
instruction sheet (LTS-1724) packed inside the UPS shipping carton.

Three- and Six-Slot Cabinets

8
NOTE Verify that all Powerware 9170 UPS power modules are the proper type for the
UPS cabinet: Universal (single-phase) modules have white labels; split-phase modules
have blue labels. Do not mix blue and white modules in the same UPS cabinet.
1. Open the top of the carton by cutting the banding straps that
hold the carton to the pallet. Open the carton flaps or lift the
cover off.
2. Remove any packing material inside the carton. Also remove
the cartons from the cabinet module slots containing front
panel bezels, electrical or mechanical hardware, and printed
material.
3. Two people are required to lift the cabinet; one to lift the two
front straps and one to lift the two rear straps.
NOTE Do not attempt to lift the cabinet by the module shelves or other convenient
edges or panels.
Powerware 9170 User's Guide
®
:
www.powerware.com