Location Requirements - Powerware Ferrups FE/QFE 500VA Installation Manual

Setup

Location Requirements

Install the FERRUPS as close as possible to the equipment to be
protected. If the UPS is more than 25 ft (7.6m) from the equipment,
transient noise can reappear in the electrical distribution system. The
UPS should be well ventilated and away from direct sunlight or other
heat source.
The environment can affect the reliability and performance of both the
UPS and the batteries. Verify the storage and operating environmental
requirements on page 21.
If additional FERRUPS system batteries are in a separate external battery
cabinet, the cabinet should be located as close as possible to the
FERRUPS UPS. If the batteries will be further from the unit than the
standard cables allow, contact your service representative or your local
distributor for assistance.
20
Powerware
I
J
Figure 4. Installation and Service Clearances
® FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide
I
G
H
H
G
:
Rev A www.powerware.com