Install Mounting Brackets
Step 3 - Attach VX6 Assembly To Bottom Mounting Bracket.
1.
Place lock washer first, then flat washer on 1/4-20x5/8 bolt. Next insert mounting bolts
through the curved apertures in the bottom mounting bracket and into the screw holes on
the side of the back mounting bracket.
2.
Loosely tighten each bolt as it is inserted.
Important:
3.
Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX6.
4.
Torque the hex bolts to 50±5 in lbf (5.64±.56 N m).
Note:
E-EQ-VX6OGWW-D
Figure 30 Attach VX6 Assembly to Bottom Bracket
Do not torque bolts until all bolts are in place and viewing angle
is adjusted.
Test the torque on the bolts frequently during operation and re-tighten if
necessary to 50±5 in lbf (5.64±.56 N m).
35
VX6 User's Guide