Step 3 - Attach Vx4 In Bracket Assembly To Bottom Mounting Bracket; Figure 18 Connect To Bottom Mounting Bracket - LXE VX4 User Manual

For microsoft windows 98, 2000 or xp equipped vx4

Hide thumbs Also See for VX4:

Table of Contents

Step 3 - Attach VX4 In Bracket

Assembly To Bottom Mounting

Bracket.

Place lock washer first, then flat washer on bolt. Next insert mounting bolts through the

curved apertures in the bottom mounting bracket and into the screw holes in the side

bracket.

Loosely tighten each bolt as it is inserted.

Important:

Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX4.

Torque the hex bolts to 50±5 in/lb (5.64±.56 N/m).

Note:

Connect all cables to the VX4. Secure the cables with the strain relief cable clamps,

ensuring a slack loop remains between the cable clamp and the accessory connector.

The vehicle mounted bracket and the VX4 are now ready to use.

VX4 User's Guide

Do not torque bolts until all bolts are in place and viewing angle

is adjusted.

Test the torque on the bolts frequently during operation and re-tighten if

necessary to 50±5 in/lb (5.64±.56 N/m).

Install Mounting Brackets

E-EQ-VX4OGWW-H-ARC

Table of Contents