Install/Remove Touchscreen Protective Film; Figure 35 Vx6 Touchscreen Protective Film - LXE VX6 User Manual

Vehicle mount computer

Hide thumbs Also See for VX6:

Table of Contents

Install Mounting Brackets

Install/Remove Touchscreen Protective Film

LXE offers a replaceable touchscreen protective film to protect the touchscreen when the VX6 is

used in an abrasive environment.

How To Install Touchscreen Protective Film

1. Make sure both the touchscreen and protective film are clean and dry before installation.

Please review "Cleaning the Display", later in this guide, for instructions on suitable cleani

2. Center the protective film over the touchscreen. The antiglare side must be facing outward.

Do not cut or trim the protective film.

3. The protective film is approximately 1/10" (2.54cm) larger than the touchscreen at the centers

of the edged (indicated by the arrows in the figure above).

4. Slide the protective film so that one of the edges of the film can be slid between the

touchscreen and display housing when the protective film is re-centered on the touchscreen.

Repeat for the other three edges, ensuring the protective film is centered over the touchscreen

when finished.

How to Remove Touchscreen Protective Film

1. To remove the protective film, slide the protective film in one direction until the edge clears.

Lift up on the edge of the film so it does not slide between the touchscreen and display

housing when slid back. Repeat until all edges are free and remove the protective film.

E-EQ-VX6OGWW-D

VX6 User's Guide

Table of Contents