Hp Z620 Workstations - Lsi 9212-4I Raid Controller Guidelines - HP Z220 SFF Maintenance And Service Manual

HP Z620 Workstations — LSI 9212-4i RAID controller guidelines
See HP Z620 Workstation system board components on page 26
board connectors.
NOTE:
Hard disk drives attached to RC J8 are designated by the 9212-4i BIOS to be boot devices. If
the hard disk drive connected to RC J8 is a member of a RAID array, the RAID array is the boot device.
RAID card connector
(RC) or system board
connector (SB)
RC J8
RC J7
RC J6
RC J5
SB SATA 0
SB SATA 1
SB SATA 2
SB SATA 3
SB SATA 4
SB SATA 5
SB SCU 0
SB SCU 1
SB SCU 2
SB SCU 3
eSATA = external SATA (2 ports per cable assembly)
HDD = hard disk drive
ODD = optical disc drive
NOTE: If there are fewer than three hard drives in the configuration, the cables from HDD bays 1 and 2
are pre-plugged to the RAID card adapter ports.
NOTE:
Only the most common configurations are shown here.
Drive installation scenarios
1
SAS HDD 1 SAS HDD 1-B
SAS HDD 2 SATA HDD 2-D
SAS HDD 3 SATA HDD 3-D
SAS HDD 4 SATA HDD 4-D
—
—
ODD 1
ODD 2
eSATA (top) eSATA (top)
eSATA (bottom) eSATA (bottom)
—
—
—
—
to determine the location of system
2
SATA HDD 1-B
SAS HDD 2-D
SAS HDD 3-D
SAS HDD 4-D
— —
— —
ODD 1 ODD 1
ODD 2 ODD 2
eSATA (top)
eSATA (bottom)
— —
— —
— —
— —
Component replacement guidelines
3
99