Hp Z620 Workstation Specifications - HP Z220 SFF Maintenance And Service Manual

HP Z620 Workstation specifications

Processor
technology
Power supply
Memory
technology
Graphics cards
I/O technology
28 Chapter 1 Hardware overview
Intel Series C602 chipset with:
®
Support for the Intel® Xeon™ Processor E5-1600 Series and E5-2600 Series
●
Integrated 4-channel memory controller
●
Microarchitecture improvements
●
Large L3 cache for superior performance
●
Intel QuickPath Interconnect (QPI) connects processors and I/O controller with speeds up to 8
●
GT/s
800W Gold, 90% efficient, wide-ranging, active Power Factor Correction, two auxiliary dongles
●
on two separate 12V rails, ERP 0.5W, Built-in-Self Test (BIST)
Dual in-line memory modules (DIMMs) based on DDR3 1600MHz technology
●
Error checking and correcting (ECC)-protected
●
Eight direct-attach memory channels (four per CPU) enable low-latency access and fast data
●
transfer for improved performance
Configurations with one CPU have eight DIMM slots; a second CPU adds four more DIMM slots
●
With one processor, up to 64 GB system memory (8 GB DIMMs)
●
With second processor, up to 96 GB system memory (8 GB DIMMs)
●
1600 MHz 2, 4 GB ECC unbuffered DIMMs
●
1600 MHz 4, 8 GB ECC registered DIMMs
●
NOTE:
Do not mix any of the different types (unbuffered, registered, and load reducing DIMMs) of
memory. The system will not boot and will produce a memory error.
NOTE:
For maximum performance, on workstations with two CPUs, install the same number of
DIMMs per CPU and install them in pairs of the same size.
NOTE: Distribute DIMMs across all memory channels for optimal performance.
PCIe Gen3 (PCIe3) bus speeds; can support two PCIe Gen3 graphics cards in PCIe3 x16 slots
●
Up to 225W graphics or compute card in the primary graphics slot
●
A second graphics card in the second PCIe3 x16 slot
●
Third and fourth 2D graphics cards in additional PCIe2 slots
●
Combined power consumption of all cards cannot exceed 300W (subject to overall system
●
power limitations and configuration restrictions)
SATA RAID 0/1/5/10 on either AHCI or SCU
●
SAS RAID 0/1/10 on SCU
●
Ten SATA ports (2 AHCI 6 Gb/s, 4 AHCI 3 Gb/s, 4 SCU 3 Gb/s)
●
Two ports available for optional eSATA
●
Four external USB 3.0 ports (2 front, 2 rear)
●
Five external USB 2.0 ports (1 front, 4 rear)
●
Six internal USB 2.0 ports
●