Table of Contents
Advertisement
D-Fi™ 2.4 Ghz
The Freedom™ series can be configured to control two or more products with no
external controllers or with the IRC from CHAUVET ® (sold separately). To manually set
(IR/Standalone
up the D-Fi™ syncing function for IR/standalone functionality, do the following:
Mode Manual
Sync)
For the transmitting product:
1.
2.
3.
4.
5.
6.
7.
8.
For the receiving product(s):
1.
2.
3.
4.
5.
6.
Once the steps above are done, you can then back out and configure the transmitting
product to operate it in either Automatic Mode or with an IRC (sold separately).
To configure your product to work in Automatic Mode, refer to the
section of the Operation section of this manual.
To configure your product to work with the CHAUVET ® IRC, refer to the
Remote Control)
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either 3-
channel or 4-channel).
Page 22 of 28
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until t.CH appears on the display.
Press <ENTER>.
Use <UP> or <DOWN> to select the transmitting signal (t001–t016).
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SLAv.
Press <ENTER>.
Press <UP> or <DOWN> until r-st appears on the display.
Press <ENTER>.
Use <UP> or <DOWN> to select the receiving signal (r001–r016). The channel
number should match the transmitting signal you chose in the prior steps.
section of the Operation section of this manual.
Automatic Mode
IRC (Infrared
Freedom™ series User Manual (Rev. 06)
Advertisement
Table of Contents
