Table of Contents
Advertisement
D-Fi™ 2.4 Ghz
The Freedom™ series can be configured to control two or more products with no
external controllers or with the IRC from CHAUVET ® (sold separately). To
(IR/Standalone
automatically set up the D-Fi™ syncing function for IR/standalone functionality, do the
Mode Auto Sync)
following:
For the transmitting product:
1.
2.
3.
4.
5.
6.
7.
8.
For the receiving product(s):
1.
2.
3.
4.
5.
6.
Once the steps above are done, press and hold <AUTO> on both the transmitter and
receiver for approximately 20 seconds. The display and signal LED will flash to indicate
sync is activated.
You can then back out to a more general menu level and configure the transmitting
product to operate it in Automatic Mode or with an IRC (sold separately).
To configure your product to work in Automatic Mode, refer to the
section of the Operation section of this manual.
To configure your product to work with the CHAUVET ® IRC, refer to the
Remote Control)
To add additional products, after syncing each one, turn the synced product off and
repeat the above steps with the new product. Once all products are synced, turn them
all back on.
Auto scan syncing must be done within a distance of about 32 ft (10 m).
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either
3-channel or 4-channel).
Freedom™ series User Manual (Rev. 06)
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SYS.
Press <ENTER>.
Press <UP> or <DOWN> until S-tr appears on the display.
Press <ENTER>.
Press <UP> or <DOWN> until tA.s appears on the display.
Press <ENTER>.
The display should show t-AU.
Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
Use <UP> or <DOWN> to select SLAv.
Press <ENTER>.
Press <UP> or <DOWN> until rA.S appears on the display.
Press <ENTER>.
The display should show r-AU.
section of the Operation section of this manual.
Automatic Mode
IRC (Infrared
Page 21 of 28
Advertisement
Table of Contents
