D-Fi™ 2.4 Ghz (Dmx Mode Manual Sync) - Chauvet Freedom Par Tri-6 User Manual

D-Fi™ 2.4 GHz
(DMX Mode
Manual Sync)
Page 12 of 22
The Freedom™ Par Tri-6 series offers wireless control of 2 or more products with a single DMX controller.
To manually set up the D-Fi™ 2.4 GHz syncing for DMX, do the following.
For the transmitting product:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until dtCH appears on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select the transmitting signal (dt 1–dt16).
For the receiving product(s):
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until drCH appears on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select the receiving signal (dr 1–dr16). The channel number should match
the transmitting signal you chose when setting up the transmitting product.
To sync multiple transmitters in one room, manually set each receiver and the designated
transmitter to a specific frequency and then perform the syncing steps.
Freedom™ Par Tri-6 is fully compatible with the D-Fi™ 2.4 GHz wireless transceiver
(transmitter/receiver) from Chauvet (sold separately).
For more detailed information about D-Fi™ 2.4 GHz functionality, refer to the D-Fi™ 2.4 GHz User
Manual available at the Chauvet website
Manual syncing is recommended for best results.
www.chauvetlighting.com.
Freedom™ Par Tri-6 User Manual Rev. 1